H&K HK 45C/USP/P2000 Extended Magazine Release

I love this upgrade but I only had 45 HK pistols..and a lot of them at that. This was great until I got a USP Tactical in 9mm. I kept having the mags drop out loaded. I thought it was me then when I had others shoot the pistol the mags would fall out after a couple of rounds at best. Long story short is this has a narrower catch than OEM and rubs down the slot on the polymer mags. It's not an issue with the steel 45 mags. I would not recommend this for poly mags. It puts premature wear on the mags and makes a great pistol unreliable.

This magazine release is a seriously good upgrade for the P2000SK. I have arthritis in my fingers, so I hated the tiny tiny tiny magazine release that comes with the P2000SK. When I received my P2000SK, I purchased and installed the wedge-shaped magazine release, but that one is incredibly sharp and ate into my fingers every time I fired the pistol; even Dremeling the sharp edges did not help. Eventually this magazine release came back in to stock and I snapped one up. It takes about 3 minutes to install and makes a world of difference. Now my P2000SK is a joy to shoot. Along with the HK P30SK, VP9SK Magazine Floor Plate installed on my magazines, my P200SK is now my favorite CCW EDC.

Just installed this on my P2000SK. Went on well Works beautifully and so easy to use. Getting the spring in is a bit of a chore, but so worth it. As others have said, this should be standard on the P2000 series.

This is an absolutely required upgrade for a P2000. It's not even funny how much more usable this is compared to the stock one. The stock mag release is barely usable, impossible to reach with my thumb, and requires way too much force to release.. This seriously needs to be the default mag release. In fact, HK should do a recall, dump all the stock mag releases into a landfill, send everyone these, and put a picture of the guy who designed the original on the pillar of shame forever. Tip: Getting the spring installed is not easy. I used a thin metal wire (a thin unfolded paperclip) to compress the spring to get it past the notch. Hold the wire on both sides, the wire perpendicular to the trigger, and press it against the spring to compress it into the hole while you work the mag release into place into the notch.

Honestly I'm annoyed I didn't get this sooner. Fantastic product and it took less then 5 minutes to install, and it is a drastic improvement over stock for the p2000.

Game changer. Easy install. Wouldn’t own anything else for my USP .45 and P2000 9mm

I’ll just echo the comments of everyone else. This is an absolute game changer. Extremely easy install. Extremely effective. Extremely cheap!! Surface area on this new part is increased enough so that your trigger finger now can EASILY activate the mag release without changing your shooting grip. It’s like buttah!! Just buy it- you’ll see.

Extremely easy to install, takes probably 30 seconds and does what it's supposed to. I didn't even realise there were enhanced versions as well

Nice sized mag release Works great. Easy install

Very easy install and a needed improvement on my USPC.