HKP/H&K P30/P30L .40 S&W Micro Comp - Threaded 9/16x24

• Threaded 14.5x1
• Includes Allen Wrench

Compatible With:

• HK VP40/VP40T
• HK P2000/P2000SK
• HK USP40
• HK P30/P30L
• Glock
• Sig Sauer
• .40 S&W Firearms Threaded 9/16x24

Installation Guide:

1. Make sure, firearm is clear & unloaded...triple check to be sure firearm is "unloaded & safe". Apply throughly  the " Vibra Tite" to the threads of the barrel and the screws before install and let sit.

2. Screw micro comp onto barrel all the way until fully screwed on and/or stops

3. Back off and unscrew the comp as little as possible to time the 3 ports at the 12 o'clock position

4. Make sure the comp is timed with the 3 oval sized ports at 12 o'clock

5. Add a drop of blue Loctite to the threads of each set screw (red Loctite or Rockset are even better)

6. Tighten down set screws 1/4 turn at a time and rotate between them 1/4 turn at a time with the hex tool provided but do not over tighten with the provided set screw wrench (make sure the comp remains timed)

7. Using a torque wrench set at 12 pounds. Do not over tighten. The torque setting is sufficient.

8. Allow the Loctite / Rockset to cure for a few hours before taking firearm to the range

Please note: Allen wrench for the set screw is included.