Description
RCM HK MP5K/N/PDW # 28 Locking Piece 80 Degree
This part is used in conjunction with a suppressor and 147-grain or heavier ammunition. This item is made 100% here in the US from enhanced steel and heat treated to the proper specifications.
Compatible With:
- MP5K
- MP5K-N
- MP5K-PDW
- SP89
- Other custom builds or clones
Warranty Information
Additional Information
Origin: |
USA |
Firearm Model: |
MP5K |
Firearm Model: |
MP5K-N |
Firearm Model: |
MP5K-PDW |
Firearm Model: |
HK SP89 |
Firearm Model: |
Clones |
Material: |
Steel |
3 Reviews
-
RCM are to spec
Don’t listen to the Guy that left a bad review with the PTR. Read about the PTR online and the complaints about them being out of spec, ask me how I know. Anyways if you have a gun that is made to spec this will fit perfectly, if you have a PTR most likely it will not. You’ll have to buy a RCM carrier to make it fit like me or mill it like that other dude.
-
It works!
Good quality fits my SP5K PDW without any fitting needed. Bolt gap measured at 0.014 in. Have gone through only about 150 rounds. Both 147 gr and 115 gr suppressed would run flawlessly. Without a suppressor, 115 gr would not cycle, and 147 gr had no issues.
-
It's a basis to start.
Locking peice did not fit my PTR 9k I has to mill the top and bottom and lathe the shaft to make it fit. The angle and locking peice was ok. After I did all that It actually worked. So unless you have a mill and lathe I suggest getting the oem hk if you can find it. 300 rounds with out a jam
Related Products
Related Products
HK MP5K, SP5K Locking Piece #28 - 80 Degree - 9mm
H&K Heckler & Koch
HK MP5, MP5K Locking Piece - 100 Degree - RCM
RCM
HK MP5, SP5 Locking Piece #27 - 90 degree
RCM
HK MP5K, SP89 Locking Piece - 110 Degree - 9mm
RCM
HK MP5, MP5K Locking Piece - 100 Degree
HKP HK Parts